Yocan Draco Mini Herb Grinder Manual

Charging the Yocan Draco Mini Herb Grinder 

1. Take the USB type-C charging cable included in the box.  
2. Connect it to the Yocan Draco Mini Herb Grinder.  
3. Get a compatible wall adapter.  
4. Plug the wall adapter to a wall socket.  

Note: The charging port is located at the top part of the Yocan Draco Mini Herb Grinder. If you can’t find a wall adapter, you can connect it to your computer. Per the manufacturer, avoid charging the Yocan Draco Mini Herb Grinder with a powerbank with an output higher than five volts. Do not charge in your car or overcharge the battery as this can result in battery damage and frying of the internal system. 

Turning the Yocan Draco Mini Herb Grinder on or off 

1. Make sure to fully charge the Yocan Draco Mini Herb Grinder.  
2. Locate the power button and press it five times quickly to power it on.  
3. Pressing the same power button five more times after it has been powered on will result in it being turned off.  

Note: The power button is located on the Yocan Draco Mini Herb Grinder’s magnetic lid. It is the circular button with similar circular patterns.  

Activating the different modes of the Yocan Draco Mini Herb Grinder 

1. Make sure that the Yocan Draco Mini Herb Grinder is fully charged.  
2. Press the power button five times to power it on.  
3. You can press and hold the power button to activate the on demand mode.  
4. Conversely, you can press the power button two times to switch to auto mode.  

Note: On demand mode means that you activate the grinder motor by pressing and holding the power button. The motor will stop running as soon as you lift your finger from the button. On the other hand, auto mode means that the motor will continue to run until the herbs are cut into fine portions and it will stop automatically.  

Loading and unloading the Yocan Draco Mini Herb Grinder 

1. Make sure that the Yocan Draco Mini Herb Grinder is powered off, you can press the button five times to make sure that the grinder is turned off.  
2. Give the magnetic lid a pull and wait for the attraction from both poles to be severed.  
3. Load a small amount of herbs.  
4. Replace the magnetic lid and begin to power the Yocan Draco Mini Herb Grinder on.  
5. When the herbs are ground, give the electric grinder a soft tap.  
6. Pull the bottom compartment off the base, which is also connected magnetically.  
7. Collect the ground plant matter and transfer to a container.  
8. Replace the magnetic compartment back to the base of the Yocan Draco Mini Herb Grinder.  

Care and maintenance for the Yocan Draco Mini Herb Grinder 

1. Make sure that the Yocan Draco Mini Herb Grinder is powered off.  
2. Take the included cleaning brush and proceed by cleaning the stainless steel blades.  
3. You may use the same brush to clean the inside of the Yocan Draco Mini Herb Grinder.  
4. Get dry cleaning wipes and wipe the edges of the lid as residual material may build up here over time.  
5. Do the same for the magnetic herb catcher as the pollen from your herbs will cause the edges to develop residue over time.