Yocan Groote Box Mod Manual

A Basic Overview of Using the Yocan Groote Box Mod Vaporizer:  

Preparing the Yocan Groote Box Mod Vaporizer

1. Ensure that the Yocan Groote Box Mod is fully charged before use for great results.
2. After charging the battery, turn the Yocan Groote Box Mod Vaporizer on by tapping on the power button 5 times rapidly. Note: The power button is located at the upper portion of the battery just right above the ribbed edges that improve your grip on the device. The power button is the diamond-shaped button that illuminates when on.

Loading the Yocan Groote Box Mod Vaporizer

1. Set your cartridges, prepare them somewhere where there’s a leveled platform so the cartridges will remain safely in place or won’t fall off the table and cause the cartridge to break.
2. Attach your cartridge to the included 510-threaded magnetic adapter.
3. Connect the 510-threaded connector from your cartridge to meet the receiving end of the magnetic adapter. Twist the magnetic adapter lightly until you feel resistance. Note: Do not over tighten the magnetic adapter as it may cause the threads to get loose. This may cause other cartridges to experience a loose connection affecting the flow of electricity and the overall performance of the Yocan Groote Box Mod Vaporizer.
4. Once the adapter is connected to the cartridge, you may conveniently insert the cartridge down to the Yocan Groote Box Mod Chamber until you hear a snap.

Vaping with the Yocan Groote Box Mod Vaporizer

1. Make sure that the Yocan Groote Box Mod Vaporizer is charged and is loaded with your select cartridge before you start vaping.
2. After you have loaded the Yocan Groote Box Mod Vaporizer with your desired cartridge, press your lips near the mouthpiece of the cartridge and prepare to draw.
3. Press and hold the power button of the Yocan Groote Box Mod and once the Yocan Groote Box Mod Vaporizer generates vapors pull and inhale from the mouthpiece of the cartridge.
4. Repeat this process as necessary or until the extracts inside the cartridge is fully consumed.

Switching Through the Temperature Settings

1. Power the Yocan Groote Box Mod Vaporizer on by rapidly clicking the power button 5 times.
2. You can check if the proper action has been performed by looking at the diamond-shaped power button, it should illuminate.
3. Tap the power button three times rapidly to toggle in between heat settings.
4. Release the power button to allow the selected heat setting to take effect on the Yocan Groote Box Mod Vaporizer.

Below are the corresponding heat levels and their respective LED light indicators.

• White Light: Low Level
• Blue Light: Medium Level
• Green Light: High Level

Care and Maintenance of the Yocan Groote Box Mod Vaporizer

The Yocan Groote Box Mod Vaporizer was made to accommodate a wide variety of cartridges. The Yocan Groote Box Mod in itself is just a Box Mod and comes with no atomizers on it, it does not come with any type of atomizer or cartridge out of the box. To ensure your Yocan Groote Box Mod Vaporizer stays in good shape, follow the steps below.

1. Wipe-off any liquid residue and remnants on the vaporizer with a dry paper towel and continue with wiping the Yocan Groote Box Mod Vaporizer with a dry paper towel until clean.
2. You can also wipe the magnetic contacts to wipe off the smudges and the dirt that may cause unstable flow of electricity.
3. Make sure to follow charging instructions and use the dedicated charger to avoid damaging the Groote Box Mod.