Yocan Red Berserk Torch Manual

Operating the Yocan Red Berserk Torch

1. Make sure the trigger is not locked.  
2. Press the trigger and hold the button.  

Note: The locking and unlocking mechanism of the Yocan Red Berserk Torch can be found on the rear end of the torch lighter.  

Adjusting the flame of the Yocan Red Berserk Torch

1. Locate the adjustment knob on the Yocan Red Berserk Torch.  
2. Rotate the knob to the right to decrease the heat and reduce the reach.  
3. Rotate the knob to the left to increase the heat and improve the reach.  
4. Locking the Yocan Red Berserk Torch Flame  
5. Locate the locking mechanism at the rear end of the Yocan Red Berserk Torch.  
6. Slide the locking mechanism to the right to lock the flame.  

Note: The adjustment tool can be found on the rear end of the Yocan Red Berserk Torch.  

Refilling the Yocan Red Berserk Torch

1. Turn the Yocan Red Berserk Torch upside down.  
2. Get your butane canister and prop the pump tube to the refilling slot.  
3. Press the butane canister down until the butane tank is full.  

Note: Check the window to see how much butane has been loaded or wait for 10 seconds for the tank to be filled. Wait for two minutes before using again.  

Cleaning and maintenance of the Yocan Red Berserk Torch

1. Wipe the Yocan Red Berserk Torch with either a damp cloth or a clean dry paper towel.  
2. Clean any dirt, grime, or residue.  
3. Always keep the Yocan Red Berserk Torch standing upright (unless when refilling) to avoid leaks.  

Note: The Yocan Red Berserk Torch is designed to stand upright during storage. 

Storing the Yocan Red Berserk Torch 

1. To store the Yocan Red Berserk Torch, make sure to clean it first following the above instructions.  
2. Use the bear-like figure to stand the torch lighter upright propped on the shoulders of the bear.