Yocan The One Vaporizer Manual

Preparing the Yocan The One Vaporizer Atomizer Coils

1. Ensure that the Yocan The One Vaporizer is fully charged before use. To experience optimum results, practice fully charging the device every time before you use it.
2. After the Yocan The One Vaporizer is charged, power it on by hitting the power button 5 times consecutively. Note: The power button is the circular button located at the middle part of the battery facing outwards.
3. Next, begin sterilization of the heating element on the Yocan The One Vaporizer. Press and hold the power button for 5 seconds two or three times. Note: perform sterilization during the first time you receive your Yocan The One Vaporizer. This will eliminate and get rid of any impurities that might have made its way to the heating chamber during the manufacturing process.
4. After you’re finished with sterilization, let the Yocan The One Vaporizer sit and rest for about 2 – 3 minutes. After it cools down, you can start using the Yocan The One Vaporizer.

Preparing the Yocan The One Vaporizer Water Bubbler

1. Unscrew the water bubbler from the battery.
2. Fill the water bubbler with water just halfway through the pole that opens from the coils to the bubbler.
3. Wipe the bubbler dry with a clean paper towel before replacing or reseating it back to the battery.

Loading the Yocan The One Vaporizer Vape Pen Atomizer Coils

1. Set your concentrates on a piece of parchment paper or any container where you can easily pick and scoop your concentrates upon loading.
2. Make sure you’ve prepared your Yocan The One Vaporizer first if it’s the first time you’re using it. Note: Follow steps for preparing the Yocan The One Vaporizer.
3. Twist the medical-grade glass bubbler counterclockwise to reveal the Yocan Quartz Dual Coils (QDC). Removing the bubbler exposes the coils that are covered with the coil cap.
4. Perform the same steps to remove the coil cap.
5. Load desired amount of concentrate atop the coil. Note: Make sure that the dab tool does not touch the coils as contact with another metal may cause the coils to break or get damaged. Simply drop the concentrates atop the QDC.
6. Tighten and replace the coil cap by twisting it clockwise.
7. Perform the same action to replace the medical-grade glass bubbler. Note: make sure that you do not overtighten the threads as it may damage it and cause it to be loose altogether.

Vaping with the Yocan The One Vaporizer Atomizer Coils

1. Make sure that you have properly sterilized and have properly loaded the Yocan The One Vaporizer before use.
2. After you’ve loaded your desired amount of concentrates onto the dual quartz coil, take the glass bubbler close to your lips against it and prepare to draw from the glass bubbler.
3. Press and hold the power button and at the same time inhale the vapors are produced by the Yocan The One Vaporizer.
4. Repeat this process as necessary or as the concentrates in the coils are fully consumed.

Vaping with the Yocan The One Vaporizer Nectar Collector

1. Prepare a torch or a lighter which you’ll use to heat up the titanium nails.
2. Prepare the grade 2 titanium nails included in the Yocan The One Vaporizer.
3. Unscrew the bubbler from the battery.
4. Set the battery aside.
5. Take the glass bubbler and attach it to the 510-threaded grade 2 titanium nails.
6. Fire up the torch and heat the nails up.
7. Once the nails are glowing red, dip it on the glass concentrate jar and start dabbing.

Care and Maintenance of the Yocan Zeus Vaporizer

The Yocan Zeus Vaporizer have different parts which require different means of care and cleaning. To clean your Yocan The One Vaporizer, follow the steps below.

1. Power on your Yocan The One Vaporizer. Five clicks will turn it on and five clicks will turn it off.
2. Turn the Yocan The One Vaporizer upside down.
3. Proceed with a burn-off by pressing and holding the power button for 5 seconds. Repeat this process 2 – 3 times. This will cause wax concentrate buildup to melt or evaporate.
4. Detach the glass bubbler and let warm water run onto it.
5. Let the vaporizer cool down.
6. Wipe off the Yocan The One Vaporizer and the parts with a dry paper towel and reassemble.