Yocan iShred Vaporizer Manual

Preparing the Yocan iShred Vaporizer

1. For best results, make sure that your Yocan iShed Vaporizer is fully charged before you use it.
2. Once you have secured a full charge on the Yocan iShred Vaporizer, turn it on by clicking the power button 5 times. Note: The power button is located at the middle part of the battery facing outwards just above the LCD screen. Take not of the power icon atop the LCD display screen.
3. Once the Yocan iShred Vaporizer is turned on you can sterilize the heating element by pressing and holding the same power button for 5 seconds two or three times consecutively. Note: perform sterilization during the first time you receive your Yocan iShred Vaporizer. This will eliminate and get rid of any impurities that might have made its way to the heating chamber during the manufacturing process.
4. After you’re finished performing the sterilization process, you can let the vaporizer sit and rest for about 2 – 3 minutes. After you’ve let the vaporizer cool down, you can now load your select dry herb materials to your Yocan iShred Vaporizer.

Loading the Yocan iShred Vaporizer

1. Prepare your botanical plant matter first. For best results, use the integrated grinder on the Yocan iShred to grind the herbs to smaller pieces allowing more materials to touch and make contact with the heated surface area.
2. Make sure you’ve prepared your Yocan iShred Vaporizer first especially if it’s the first time you’re using it. Note: Follow steps for preparing the Yocan iShred Vaporizer.
3. Remove the mouthpiece to expose the herb heating chamber.
4. Use a loading tool to scoop the herbs or simply transfer the ground herbs from the grinder straight to the herb chamber.
5. Replace the mouthpiece and ensure a tight seal so the vapors won’t escape the chambers.

Grinding Your Herbs Using the Integrated Grinder

1. Locate the grinder at the bottom of the Yocan iShred Vaporizer.
2. Twist the grinder counter clockwise to access and detach the grinding piece.
3. Place an appropriate number of herbs on the grinder.
4. Replace the grinding piece and start milling. The grinder also has a pollen catcher so you can collect pollen from the materials you grind.

Vaping with the Yocan iShred Vaporizer

1. Make sure that the Yocan iShred Vaporizer is properly sterilized, fully charged, and is loaded with ground botanicals before vaping.
2. Once loaded, take the mouthpiece and press your lips against it and prepare to draw.
3. Press and hold the power button for three seconds to activate the heating element.
4. Wait till the Yocan iShred Vaporizer begins producing vapors, inhale and pull from the vaporizer.
5. Repeat this process as necessary or as the herbs are fully consumed. Note: Stir your herbs from time to time for an even burn using the built-in stirrer in the mouthpiece.

Care and Maintenance of the Yocan iShred Vaporizer

The Yocan iShred Vaporizer is made with very few parts which make it a solid device and is likewise straightforward to clean and maintain. To clean your Yocan iShred Vaporizer, follow the steps below.

1. Make sure to turn the vaporizer off. Five clicks will turn it on and five clicks turns it off.
2. Remove the mouthpiece to access the herb chamber.
3. Take the included cleaning brush and lightly graze over the heating chamber.
4. Replace the mouthpiece.