Yocan Rega Box Mod Vaporizer Manual

Preparing the Yocan Rega Box Mod Vaporizer

1. Ensure that the Yocan Rega Box Mod is fully charged before usage for optimum results.
2. After the battery is charged, turn the Yocan Rega Box Mod Vaporizer on by tapping on the power button 5 times. Note: The power button is located at the upper right-hand corner of the battery just right above the ribbed edges that improve your grip on the device. The power button is the square button that illuminates when on.

Loading the Yocan Rega Box Mod Vaporizer

1. Prepare your cartridges, place them somewhere where there’s a leveled platform so the cartridges will remain safely in place.
2. Attach your cartridge to the included 510-threaded magnetic connector.
3. Place the 510-threaded attachment from your cartridge to meet the receiving end of the magnetic adapter. Twist the magnetic adapter until you feel resistance. Note: Do not over tighten the magnetic adapter as it may cause the threads to get loose. This may cause other cartridges to experience a loose connection affecting the flow of electricity and the overall performance of the Yocan Rega Box Mod Vaporizer.
4. Once the adapter is connected to the cartridge, you may insert the cartridge down to the Yocan Rega Box Mod Chamber until you hear a snap.

Vaping with the Yocan Rega Box Mod Vaporizer

1. Make sure that the Yocan Rega Box Mod Vaporizer is charged and is loaded with your select cartridge before you start vaping.
2. After you have loaded the Yocan Rega Box Mod Vaporizer, press your lips near the mouthpiece of the cartridge and prepare to inhale.
3. Press and hold the power button of the Yocan Rega Box Mod and once the Yocan Rega Box Mod Vaporizer generates vapors pull and draw from the mouthpiece of the cartridge.
4. Repeat this process as necessary or until the extracts inside the cartridge is fully consumed.

Switching Through the Temperature Settings

1. Power the Yocan Rega Box Mod Vaporizer on by clicking the power button 5 times.
2. You can check if the proper action has been performed by looking at the power button itself, it will blink or flash.
3. Tap the power button three times rapidly to toggle in between heat settings.
4. Release the power button to allow the selected heat setting to take effect on the Yocan Rega Box Mod Vaporizer.

Below are the corresponding heat settings and their respective voltage levels.

• White Light: Low Setting
• Blue Light: Medium Setting
• Green Light: High Setting

Care and Maintenance of the Yocan Rega Box Mod Vaporizer

The Yocan Rega Box Mod Vaporizer was made to accommodate a wide variety of cartridges that measure up from 9 – 11.5 mm in diameter. The Yocan Rega Box Mod in itself is just a Box Mod with no atomizers on it it does not come with any cartridge out of the box. To ensure your Yocan Rega Box Mod Vaporizer stays in good shape, follow the steps below.

1. Wipe-off any liquid residue on the vaporizer with a dry paper towel and continue with reassembling the Yocan Rega Box Mod Vaporizer.
2. Make sure to follow charging instructions and use the dedicated charger to avoid damaging the Rega Box Mod.