Yocan Torch 2020 Enail Manual

Preparing the Yocan Torch Enail

1. Ensure a fully charged battery with the Yocan Torch Enail before use for the best results.
2. Once the battery is fully charged, turn the Yocan Torch Enail on by pressing the power button 5 times quickly in two seconds.

Note: The power button is the circular button located at the topmost part of the battery with the power icon.

Loading the Yocan Torch Enail

1. Prepare your wax concentrates, use the inclusive dab tool to pick your extracts when loading the Torch Enail.
2. Open the chamber by removing the metal tube away from the atomizer coils. Simply pull the mouthpiece away from the coils. The metal tube is connected to the base of the coil cap using O-rings.
3. Carefully twist the coil caps and unscrew it from the coil.
4. Load your extracts to the coil using the dab tool.
5. Replace the coil cap.
6. Replace the metal tube by pressing it against the base of the atomizer.

Note: Avoid touching the coils with the dab tool as it can get damaged if the coils are bumped out of place. Carefully place the wax concentrates above the dual quartz rods without touching the metal coils. Leftover wax on the dab tool can be scraped on the sides of the coils. This process is the same for both the quartz dual coils and the pancake dual coils (pancake dual coils not included).

Vaping with the Yocan Torch Enail

1. Make sure that the Yocan Torch Enail is fully charged and is loaded with your select wax concentrates.
2. After you have loaded the Yocan Torch Enail, press your lips near the mouthpiece of the atomizer or cartridge you’re using and prepare to inhale.
3. Press the power button of the Yocan Torch Enail once and when the heating element creates vapors pull and draw from the mouthpiece.
4. Repeat this process after your dabs are fully vaporized or you may stop after a full cycle.

Care and Maintenance of the Yocan Torch Enail

The Yocan Torch Enail is made only with few parts making it a solid device that is relatively easy to clean and maintain. The Yocan Torch Enail is a wax concentrate enail and requires only a few steps to clean. To clean your Yocan Torch Enail, follow the steps below.

1. Wipe-off any residue on the battery with a dry paper towel and continue to reassemble the Yocan Torch Enail.
2. Make sure to follow charging instructions and use the dedicated charger to avoid damaging the Yocan Torch Enail.